View Single Post
  #22   Spotlight this post!  
Unread 30-01-2017, 14:08
RoboChair's Avatar
RoboChair RoboChair is offline
He who fixes with hammers #tsimfd
AKA: Devin Castellucci
FRC #1678 (Citrus Circuits and 5458 Digital Minds)
Team Role: Mentor
 
Join Date: Jan 2007
Rookie Year: 2005
Location: Davis, CA
Posts: 715
RoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond reputeRoboChair has a reputation beyond repute
Re: Tubing for ball intake

Quote:
Originally Posted by Skyehawk View Post
I was more referring to a non-compressed air approach, however, 250 thou is a lot to overcome for an interferance fit, even with an 'easily' yielding material. Probably not possible.

How do you adjust the ends of the rollers? i.e. move the last inch of the latex up to your mark on the Al tubing?
Razor blade. If I want a 24" roller, I NEED a piece at least 28" long and cut to the 24" mark when I float the end to the right position. I will also demonstrate how we make segmented rollers with multiple pieces on one length of roller.
__________________

12 Years and counting! Over a third of my life has been spent with FRC.
Reply With Quote