Thread: Robot deletes robot code after disabling it
View Single Post
  #1   Spotlight this post!  
Unread 31-01-2017, 09:15
ebernerrd ebernerrd is offline
Registered User
FRC #3236
  
Join Date: Jan 2017
Location: Franklin, MA
Posts: 8
ebernerrd is an unknown quantity at this point
Robot deletes robot code after disabling it
Hey there again!
I am running a command based robot. When I enable it for teleop mode, everything works perfectly. If I disable the robot, and then attempt to re-enable it, the roborio stops comms with the driver station and deletes the code off the roborio. i have to either reset the robot code from the DS every time I disable it before re-enabling it, or let it crash and reboot the roborio and reupload the code.

Any reason for this?
Thanks!
-Eric
Reply With Quote