View Single Post
  #9   Spotlight this post!  
Unread 01-02-2017, 20:12
MrBasse MrBasse is offline
Registered User
FRC #3572 (Wavelength)
Team Role: Coach
 
Join Date: Jul 2011
Rookie Year: 2010
Location: Norton Shores, MI
Posts: 688
MrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond reputeMrBasse has a reputation beyond repute
Re: poly cord advice

We made a jig out of a chunk of 2" diameter aluminum. Drilled a .25" hole through it then cut it in half on the band saw straight down the hole. Heat the cord, stick together in the jig and clamp it. The aluminum does a good job of pulling the heat out of the belt and it cures in under 5 minutes.

Since we made two of those we haven't had a failed belt. Prior to that we had one fail every four or five times. With the two pucks we made, we can weld one and while that cures set the next one up.
__________________
Andrew Basse
Coach - FRC Team 3572 - Wavelength
Reply With Quote