View Single Post
  #6   Spotlight this post!  
Unread 02-02-2017, 19:20
cnc4 cnc4 is offline
Registered User
FRC #2231 (OnyxTronix)
Team Role: Programmer
 
Join Date: Jul 2016
Rookie Year: 2015
Location: Israel
Posts: 21
cnc4 is an unknown quantity at this point
Re: CANTalon are broken since 2.2 frimware

Quote:
Originally Posted by ozrien View Post
You mean firmware 2.20 right?
If this is true then you should be seeing a driver station message indicating this.
Well I got lots of warnings that are saying that there is not enough output refresh or something like that. After disabling this I noticed it went away, now it's explains why.


Quote:
Originally Posted by ozrien View Post
I would recommend following the debugging steps in section 16 where applicable.
Well I realy did, I did not saw it. Thanks

Quote:
Originally Posted by ozrien View Post
There are no reported issues with 2.20 so I suspect the issue is something else.

Use the web-based config and self-test to see what state the Talon is when it's behavior is not matching your expectation (section 2).
Well the problem got solved, even the problem I debugged before (the reason I reimaged the talons) got fixed so I can totally approve you, Thanks!
Reply With Quote