|
Ni Web Based Configuration Not Showing CAN Talons
Hi,
I'm programmer for 2523, and I'm trying to get the NI Web based config up and running now that our electronics board is put together, so as to configure the CAN Talons we are using for our drive train. After updating the firmware on both the wireless access and the RoboRIO, I was able to access the configuration menu via roboRIO-2523-FRC.local, but the roboRIO is the only thing that shows up. The CAN talons do not, and the driver station does not even register any communication with the RIO. Also, the COMM light on the RIO does not turn on at all. Does anyone have any idea what could be causing this, or at least whether it's a hardware or software issue?
Side Note: This is my first post on here, so let me know if this is in the wrong place.
|