|
Re: Ni Web Based Configuration Not Showing CAN Talons
There are three things:
- updating roboRIO firmware (not necessary if it's at 3.0.0) The version is listed on the roboRIO web interface.
- formatting the roboRIO (puts the operating system onto the roboRIO-has the web interface)
- Downloading user code
Did you install the 3rd party CAN Talon Toolsuite, too?
The CTRE LifeBoat utility also has a tab to update the CTRE products on the roboRIO.
http://www.ctr-electronics.com/talon...ical_resources
__________________
"Rationality is our distinguishing characteristic - it's what sets us apart from the beasts." - Aristotle
Last edited by Mark McLeod : 04-02-2017 at 18:03.
|