Thread: Pressing Pinion on the Chipper
View Single Post
  #1   Spotlight this post!  
Unread 25-01-2002, 16:48
JamesJones JamesJones is offline
Registered User
#0180 (SPAM)
  
Join Date: Jan 2002
Location: Stuart, Fl
Posts: 44
JamesJones is an unknown quantity at this point
Pressing Pinion on the Chipper
Does anyone know what the inside of a Chip' motor looks like? I would like to press a different pinion on the output shaft/gear but don't want to damage anything inside (bearings).

Any advice or suggestions (Dr. Joe) would be appreciated.

Thanks.