View Single Post
  #2   Spotlight this post!  
Unread 08-02-2017, 12:26
bobbysq bobbysq is offline
Registered User
FRC #4646 (Team ASAP)
Team Role: Leadership
 
Join Date: Apr 2016
Rookie Year: 2015
Location: Des Moines, IA
Posts: 335
bobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud ofbobbysq has much to be proud of
Re: 3D printable gear hook

A bit of an extra note since I lost the ability to edit.

After printing it, it appears that it has a very tight fit in the spring. In fact, it's so tight that you need to install it by actually screwing it in to the spring, letting the metal dig through the plastic. Because of this, you will want to use a good amount of infill to keep it from shearing. I printed it at 20% and I nearly snapped it trying to get it in, so you may want a bit more if you're worried.
Reply With Quote