View Single Post
  #10   Spotlight this post!  
Unread 30-04-2003, 19:14
FreeBSDboy FreeBSDboy is offline
Registered User
#1073
 
Join Date: Apr 2003
Location: Hollis / Brookline, NH
Posts: 7
FreeBSDboy is an unknown quantity at this point
If you have access to using the dril motor / transmission from this year, you can just screw any standard drill chuck onto the threads on the end of the transmission.

If you are going to use the CIM motor, you will need to gear it down at least 10:1, which would give you a 600rpm no load speed. It does not have enough torque to drill with direct drive.