Hey guys, I want to basically wire custom toggle switches (i.e. SPST's) into one of the ports on the operator interface, so that when you flip one switch, say, pin 3 returns a 1. I did a quick and dirty (but interactive
) flash movie of basically what we want -
http://nervae.phenominet.com/first/whatwewant.html. Doing the wiring isn't exactly hard, just knowing how to wire it is a trick.
I'm not sure how these ports work, but I'm guessing each pin is some kind of 'mini-circuit' that if closed returns a 1 and if open returns a 0, meaning one of the pins is the power and the others are 'circuit pins'? ...or am I completely ouyt there? Check out my flash movie to see basically what we want to do. Any links or explinations on how to wire it would be helpful.