Thread: Mabuchi!!!!
View Single Post
  #1   Spotlight this post!  
Unread 28-01-2002, 20:05
P.J. Baker's Avatar
P.J. Baker P.J. Baker is offline
needs a clever user title
FRC #0177 (Bobcat Robotics)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 1999
Location: Hebron, CT
Posts: 110
P.J. Baker is a glorious beacon of lightP.J. Baker is a glorious beacon of lightP.J. Baker is a glorious beacon of lightP.J. Baker is a glorious beacon of lightP.J. Baker is a glorious beacon of light
2002 Mabuchi = 2001 FP?
I'll start off with a warning: Please check me on this. I do not have the motors in front of me, but I'm pretty sure that the following is true:

The Mabuchi motor included in the 2002 kit is the same motor that was supplied with the FP assemblies last year, just without a pinion. If this is true, I would have a hard time finding fault with anyone who used last year's motor and pinion on this year's robot. I will check this out tomorrow and make another post.


Otherwise, you just need to find or make a pinion that can be attached to the Mabuchi output shaft. I think the pinion supplied with the FP motors is a 16Tooth, 32 Diametral Pitch, 20 deg. Pressure angle. Something similar (or identical) to this should work fine.

Good Luck,

P.J.