Thread: Mounting Drill Motors Using Plastic Housing
View Single Post
  #2   Spotlight this post!  
Unread 30-01-2002, 15:47
Unsung FIRST Hero
Matt Leese Matt Leese is offline
Been-In-FIRST-Too-Long
FRC #1438 (The Aztechs)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 1998
Location: Long Beach, CA
Posts: 937
Matt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond reputeMatt Leese has a reputation beyond repute
Send a message via AIM to Matt Leese
First of all, just place them in the drill motor housing. Then, cut off the handle of the drill motor and mount them so that they would be right side up for a drill. Then just secure them at the top and they should reasonably stay in place.

Matt