[FotoPlasma]

The WRRF (Western Regional Robotics Forum) has been holding workshops, during the off-season, for a few years, now.

The main subjects covered are things like drivetrain design, electronics / wiring, programming, motor choice, and pneumatics. There is also a Rookie Workshop, which is used as an introduction to what new teams are getting themselves into. I believe thoughts are being thrown around about there being a CAD/Inventor workshop, along with the vague possibility of a custom circuit board workshop, but I find it almost unlikely, at this point.

Our workshops are held approximately two per day, over the course of three days. I'm not sure what the dates are set to be, for the next round of workshops, but mid-September, November, and October all ring bells.

The WRRF Workshops are a collaborative effort from many WRRF teams, so I'm not sure how a single team would go about hosting and teaching them. If you have any questions, please ask.