Thread: Mounting Drill Motors Using Plastic Housing
View Single Post
  #4   Spotlight this post!  
Unread 31-01-2002, 00:05
CharlieWilken CharlieWilken is offline
Registered User
#0634 (Robowolves)
  
Join Date: Jan 2002
Location: Van Nuys, CA
Posts: 46
CharlieWilken is an unknown quantity at this point
We just drill and tap a 3/8 24 hole in the end of a 1/2 in piece of cold rolled steel. Then put the other end of the shaft in a 1/2 inch bearing with bearing block.