Thread: using set screw or dowel pin/pin to hold on drill motor coupler thinggy
View Single Post
  #1   Spotlight this post!  
Unread 02-04-2002, 01:26 AM
Travis Covington's Avatar Unsung FIRST Hero
Travis Covington Travis Covington is offline
Engineering Mentor
FRC #0254
Team Role: Engineer
  
Join Date: Oct 2001
Rookie Year: 1998
Location: San Jose, CA
Posts: 573
Travis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond reputeTravis Covington has a reputation beyond repute
Send a message via AIM to Travis Covington
using set screw or dowel pin/pin to hold on drill motor coupler thinggy
i was wondering what would be best to attatch the drill motor extension shaft to the motor shaft with (the design is similar to team 45'sa dual gear switching design)

should we pin it using a dowel pin, regular pin, set screw *yuck* or regular thru screw?

thanks
__________________
-Travis Covington

2008-2017 - Engineering Mentor of Team 254
2001-2008 - Engineering Mentor of Team 968
1998-2001 - Mechanical Director/Driver/Member of Team 115