I didnt' figure it would, I was just using it for comparison. found that out on another project I had (DDR pad for siblings)
on these..
http://cgi.ebay.com/ws/eBayISAPI.dll...tegory=11 769
the shaft shoes to be 3/8" thread, if i read it correctly. The wheels I have have a 3/4" hole. Has anyone done something similiar to this....
Im thinkin about getting some circular stock (3/4"Diameter) and then putting a piece in the wheel, welding it in place(weld on wheel) then tap the stock for a 3/8" hole and just thread it onto the end of the wiper motor? I was going to make the stock a few inches long since the shaft on the motor is so short...
Anyone do something similiar?
I will either get 2 of those motors, or the wheelchair motors.