Thread: Plastic Motor Mount?
View Single Post
  #1   Spotlight this post!  
Unread 14-01-2004, 15:28
indieFan indieFan is offline
RoboDox and LVHS - Missing you!
FRC #5941
Team Role: Engineer
  
Join Date: Jan 2002
Rookie Year: 2001
Location: Seattle (was SoCal, then SA,TX))
Posts: 382
indieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond repute
Plastic Motor Mount?
I am currently trying to put the plastic motor mount over the Bosch drill. I finally managed to slip the drill into the large single piece, but I am finding that the three smaller pieces are not slipping on correctly. Are these pieces too small or am I doing something incorrectly?

I also moved the white ring closer to the clutch (I believe this is high gear) and locked it in place by rotating the black ring that the motor fits into 180 degrees. Could this be part of the problem?

indieFan