|
Re: Optimal Direction of the Drill and Chips
Quote:
|
Since the leads on the drill don't appear to be marked, it is possible that you will wire them backwards and reverse will be faster, in this case just swap the +V and GND wires on the output terminals of the speed controller.
|
Actually the leads of the drills are marked.  If you look carefully there is a postive mark on the one side of the drill motor.
__________________
If either a public officer or any one else saw a person attempting to cross a bridge which had been ascertained to be unsafe, and there were no time to warn him of his danger, they might seize him and turn him back without any real infringement of his liberty; for liberty consists in doing what one desires, and he does not desire to fall into the river. -Mill
|