Thread: Drill Motor Top Rear Plastic Support
View Single Post
  #1   Spotlight this post!  
Unread 22-01-2004, 02:22
sanddrag sanddrag is offline
On to my 16th year in FRC
FRC #0696 (Circuit Breakers)
Team Role: Teacher
  
Join Date: Jul 2002
Rookie Year: 2002
Location: Glendale, CA
Posts: 8,510
sanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond reputesanddrag has a reputation beyond repute
Drill Motor Top Rear Plastic Support
Well, we were mounting up our drill motors today and realized that FIRST gave us 4 top middle supports and zero top back supports instead of two top middle supports and two top rear supports. Did any one else get their kit this way? It is past the extended deadline of reporting this problem so we will be machining our own equivalents out of aluminum.

If any team did not receive these specific pieces and had planned on using them, send me a PM or post here and we'll see if we can run a couple for you. We are not machining aluminum replacements for people who got plastic ones. Perhaps for a cost we could make them for anyone but the intent of this was only wanted to ask if there's anyone we could help out who is in the same position as us.
__________________
Teacher/Engineer/Machinist - Team 696 Circuit Breakers, 2011 - Present
Mentor/Engineer/Machinist, Team 968 RAWC, 2007-2010
Technical Mentor, Team 696 Circuit Breakers, 2005-2007
Student Mechanical Leader and Driver, Team 696 Circuit Breakers, 2002-2004