Thread: Current Sensor
View Single Post
  #15   Spotlight this post!  
Unread 23-01-2004, 01:45
Vladimir Vladimir is offline
the Impaler
#1064 (Wild Beast)
Team Role: Programmer
  
Join Date: Mar 2003
Location: South Milwaukee, WI
Posts: 6
Vladimir is an unknown quantity at this point
Send a message via ICQ to Vladimir Send a message via AIM to Vladimir Send a message via Yahoo to Vladimir
Re: Current Sensor
I believe I have the current sensor wired up properly but the controller reads a number around 867 and never moves from that, no matter how much current I pass through it. I'm sure the PWM cable to the RC is aligned correctly. I tested the analog inputs with another device and they work fine (0-1023).. if I disconnect it the value floats around as it should, connect it, 867. Any ideas? Is it defective? I heatsunk it while soldering to make sure it wasn't damaged.
__________________
B.R.E.W. (Better Robots Engineered Wisely)