Quote:
|
Originally Posted by CNCBoy461
As for the question of "Where to buy the sensor package?"...WE DON'T KNOW!!! Will someone please post a reply to this, we would like 2 more of them...and if not, what's the voltage rating on the capacitor? 4vdc or 6.3vdc? Good luck all!
www.boilerinvasion.org and see pictures of the sensor (Soon) and a CAD model of the new Maxi Fuse Block. |
The Cap is limiting noise to the controler and slowing the response(slightly), voltage should be 6.3 but a higher rateing will not hurt anything and is a saftey factor. Tanyalem Caps short when they fail. Check with ohm meter, should read low to start then go to a high vaue as the cap charges. Any thing below 10 ohms after a few seconds and the cap is hosed. You allready mentioned not putting them in backward. The ACS750-75 has a link to buy more sensors at
http://www.allegromicro.com/sf/0750/ don't know about the circut board Good luck.