Quote:
|
Originally Posted by Mark McLeod
The values returned by the IR sensor are 0=sees IR, or 1=does not see IR.
Are you running the sensor from the EDU controller? If so pins 1 & 2 are setup as analog inputs. Use pin 6 instead which the default code sets up as a digital input. Make sure you get the IR sensor pins wired correctly. The center pin is the Blk or common.
[edit]
BTW you can also check to see if your beacon is emitting by pointing a digital video or still camera at it. Digital cameras can "see" the IR frequency used.
[/edit]
|
Hello,
Thanks for this information. We have another problem.
1) Is there any electrical information on the pinouts of the new joysticks?
2) Is the Operator interface controller the same pinout for inputs as last year?
Thanks,
David Bryan 818