Kevin,
On your website, you mention that there are two versions of receiver.c.
Quote:
|
As there are two different versions of receiver.c, make sure that your sensors are attached according to the instructions at the top of receiver.c.
|
WHERE are the two versions, WHAT are the differences, and - uh- WHY?
I was using a solderless breadboard to build and test the beacon and sensors before committing to a design. Using the EDU, I was going to marry the beacon driver and the receiver code into one program to get a better understanding of how this stuff works. (i.e. one program to both flash the beacons and detect it with a sensor) Unfortunately, my first attempt at that resulted in a flashing red program state LED on the EDU. I will work on it again tonight. Are there any considerations/conflicts when including receiver.c in the beacon code?