|
Re: Polycord Belting
It depends. You didn't mention the width or length of it. At work we use a kevlar reinforced belt ( .25 thick, 1.65 wide, by whatever length needed) and for 1' weighs less than a quater pound. Remember this is kevlar (metal) and not polycord (nylon) so I would say slightly less. I hope this helps and if in doubt round higher for a safety margin.
__________________
2006 Maryland Delphi "Driving Tomorrow's Technology" award
2006 Connecticut General Motor's Industrial Design award
2005 Finalists-----------New Jersey (along with our alliances again, 56 & 303)
2005 WINNERS of the Radio Shack Innovation in Control Award (not once, but twice!  )
2004 WINNERS ------ Johnson & Johnson Mid-Atlantic Regional (also thanks to our alliances 56 & 303)
2004 General Motors Industrial Design Award Winners
2004 Archimedes Quarterfinalists (also thanks to our alliances 121 & 386)
NEMO _________ NonEngineering Mentor Organization
"Make it idiot proof and someone will make a better idiot!" - author unknown
|