Thread: Cannot place constrain in Inventor
View Single Post
  #1   Spotlight this post!  
Unread 03-02-2004, 23:51
Paul Marshall Paul Marshall is offline
Registered User
no team
  
Join Date: May 2001
Location: Cupertino, CA
Posts: 43
Paul Marshall will become famous soon enough
Send a message via AIM to Paul Marshall
Cannot place constrain in Inventor
So I have a problem in Inventor. I downloaded the van door motor from FIRST CAD Library. And I made a mounting plate for it with 3 screws for the bolts and one hole in the middle for the shaft to go through. I try constrain the two together in a assembely. I first mate the van door motor to the face of the mounting bracket. Then I mate the centerline of one bolt hole to one of the holes in the bracket. Next I try and mate a second bolt hole to the second hole in the bracket except I get an error. What should I do, should I make the holes in the bracket adaptive or what?
__________________
-Paul
Last edited by Paul Marshall : 03-02-2004 at 23:52. Reason: Typo