[Matt Adams]

Could someone please address how rule 5.3.2.2 would apply to this situation? Joel brought up this concern earlier... I haven't seen a response from either team. I'm just curious about the billing rate that's appropriate.

461 has always used $50 / hr for any CNC work we've had done, but I don't know a fair rate for a typical machinist.

I'm just curious how this will all pan out... it'll be interesting to say the least. I'm not nearly as concerned about having two identical designs as I am about the whole idea of, "I'll build two of this and you build two of that, and we'll switch." It's much faster to build 2 of 1 part than 1 of 2 parts.

I know at Purdue, discussions over homework assignments is encouraged. However, writting out problem #1 twice, and having a friend write out problem #2 twice, followed by a switch of assignements doesn't fully teach either party the material in the problem they didn't do. In my mind, this homework example parallels this collaboration somewhat close.

However, I'm a little divided to be honest. It seems like this is taking something a bit too far. What that "something" is... I can't place my finger on... so apon the fence I sit, watching it unravel.

Good luck to everybody!

Matt