Quote:
|
Originally Posted by Yellow Eyes
Does anyone have a working Tracker code that we could borrow to see if our IR Works. PM a link to it.
Sorry for asking, but our code did work...and now, it doesn't. We've plugged them into the right PWMs and the IR Beacons do work...and we've even talk to Kevin...from Kevin.org. It's getting very annoying.
|
Hi Brian,
Last week, our IR receivers stopped working after we replaced a few cable connectors on the circuit board they were soldered to. We also had one stop working when we replaced the heatshrink we wrapped the receiver in.
We didn't feel we used excessive heat in either case, but when we scoped the signal pin of the IR receivers afterwards, we found that they were no longer pulling all the way down to 0V, but were floating around 2-3V instead.
-Shawn...