Quote:
|
Originally Posted by KenWittlief
cutting off at 9V? do you mean its only putting out 9V at full throttle, instead of 12?
you might need to calibrate the victors
are you sure you code is putting out 254 and 0 for full FWD and REV?
are you sure your battery is not going dead?
one other thought - if you are seeing 9V on the output of the victor make sure there really is 12V onthe input side with the motor running - maybe you have a poor connection somewhere in your power path - those big wire blocks need to be tightened up good to get a solid connection.
|
We checked the input voltage and it is 12VDC. We do not reach full throttle before it cuts out at 9 Volts. It is only the Chip and Victor on one side (we are running a dual motor, drill and chip, transmission on each side) causing the problem. Our battery is fully charged and has been changed and the problem is still there. I have checked with the programmer and even had him do a full forward in program mode. The Chip still cut off at 9 Volts. He has also reassured me that the code is set for 254 and 0 for full FWD and REV. Any other suggestions would be greatly appreciated.
Thanks,
Aaron