View Single Post
  #8   Spotlight this post!  
Unread 19-02-2004, 19:42
KenWittlief KenWittlief is offline
.
no team
Team Role: Engineer
 
Join Date: Mar 2003
Location: Rochester, NY
Posts: 4,213
KenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond reputeKenWittlief has a reputation beyond repute
Re: Is default code already loaded?

if you connect a servo to the same pwm output, and the servo moves when you move the joystick, but the victor stays on solid yellow when you connect and move the joystick, then I suspect your victor is not working correctly.

The calibration process: get the official Victor Calibration Instrument (also know as a straightened paper clip :c) and push the little tiny button on the base of the victor and hold it - the LED will start to blink.

Move the joystick all the way forward, then all the way rev, then back to center - holding the tiny button the whole time, then release the button

the light should go back to steady yellow in a few seconds.

I dont think this will fix your problem, but you can try it - I recommend you try another victor - connect it up carefully, and see if it works.