Quote:
|
Originally Posted by fred
We ran out of speed controllers (our "genius" mechanics decided that we needed that many motors) and we are using relays and spikes right now. I am trying to use relays in the code and hitting some problems. Here is what I have now.
if(p3_sw_aux1 == 1){
relay1_fwd = 127;
relay1_rev = 0;
}
else if(p3_sw_aux2 == 1){
relay1_fwd = 0;
relay1_rev = 127;
}
else
relay1_fwd = 254;
relay1_rev = 0;
the p3_sw_aux1 part appears to work and the motor doesn't move when nothing is done to it. But we are having some problems with that p3_sw_aux2 part. Any suggestions or comments would be greatly appreciated.
|
Relay outputs are 1 or 0 values, forward is 1 (on) or 0 (off), same for reverse. They have no speed control. This also means you can assign values directly from buttons. I'm not exactly sure what you were going for, but this will make aux1 make relay1 go forward, aux2 make relay1 go backward, neither button and relay outputs no power:
Code:
relay_1_fwd = p3_sw_aux1;
relay_1_rev = p3_sw_aux2;
Hope this helps.