|
Re: Drawing
You have to make a new "paper" file, its the icon that looks like a tan paper. Then you go to place componet and find you file. You can choose the scale and such in there. Then place it where you want. You may project the drawlings to top, front, and isometric if you wish. Then on the left hand tool bar, click the gray box above the place compent thing, there should be an option to go into drawling mode or something like that. When you click on that, the icons below will change and you will see general desmsion. Then you just click on the lines and drag them out.
If you want to measure it in the actual file drawling, you can just right click and go down to measure. Click on the lines you want to measure and it will give you the distance.
Sorry I don't have Inventor infront of me so the terminlogy is off, hopefully that helped. I will have Inventor back tomorrow, if you have any questions.
|