View Single Post
  #3   Spotlight this post!  
Unread 01-03-2004, 01:50
Bob92 Bob92 is offline
Registered User
no team
 
Join Date: Sep 2001
Location: none
Posts: 24
Bob92 is on a distinguished road
Re: How hard is it to CNC this?

you can actually do it on a vertical mill if you have the 1/8th inch long endmill. But you must lathe it down first and then put it in an indexing head. Then if you have the time you can rotate the piece while lowering the endmill after each rotation. Then make all the other cuts you must.