Thread: I-cylinder body wrong?
View Single Post
  #1   Spotlight this post!  
Unread 05-03-2004, 20:18
Daniel Brim's Avatar
Daniel Brim Daniel Brim is offline
It's hard hat time here in Boston
AKA: DFB
FRC #0125 (NUTRONS)
Team Role: Engineer
  
Join Date: Feb 2003
Rookie Year: 2002
Location: Boston, MA
Posts: 938
Daniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond reputeDaniel Brim has a reputation beyond repute
Send a message via AIM to Daniel Brim
I-cylinder body wrong?
I was working on our team's inventor award submission. I was working on our goal grabber when I did a constraint that was right, but it was acting wrong. I enventually looked at the actual cylinder (3" stroke, 3/4 inch bore) and it was actually 6 inches. Just to do a sanity check, I made a new one in a new assembly, and it still didn't work. Does anybody else have this problem? Is there a typo on the table (I went through and didn't notice any). Any help would be appreciated.

Thanks,
Daniel
__________________
2003 (2002) - 2006 -- Team 294, Beach Cities Robotics
2007 (2006) - Present -- Team 125, NUTRONS