[Jack Jones]

[quote=NoRemorse]Ok, just to make sure i have this right, the model must be no larger than 1"x1"x1"

I dont want to amke a model that wont work! so please confirm/deny quickly if possible![/QUOTE

Plan right now is to have each model fit into a one inch cube. However, unless demand shows a significant increase, we will up-size the requests we have so far.

So, go ahead and scale it by ( 1/{largest_dimention} ) we can always re-scale it to whatever size we decide to make them.

Jack
BTW, at the one inch size, we can burn about 1200 at a time, which is no where near the number we've been asked to make so far.