Thread: Operator Interface LED Drivers
View Single Post
  #1   Spotlight this post!  
Unread 14-03-2004, 22:46
Andrew Andrew is offline
Registered User
#0356
  
Join Date: May 2002
Location: Little Rock, AR
Posts: 393
Andrew is a name known to allAndrew is a name known to allAndrew is a name known to allAndrew is a name known to allAndrew is a name known to allAndrew is a name known to all
Operator Interface LED Drivers
Has anyone programmed the OI LED drivers in the new RC?

In the old OI/RC combo, the LED drivers were tied to outputs 12, 13, 14, and 15. Despite the documentation saying that pwm1_red, etc. are the output drivers, those drivers are only tied to the blinking lights on the OI itself and do not drive the four drivers available on ports 2 & 4.

If anyone has figured this out for the new RC, I would appreciate knowing what variable connects to these drivers.