Thread: Lasercutting Spur Gears?
View Single Post
  #1   Spotlight this post!  
Unread 08-04-2004, 17:18
AlbertW's Avatar
AlbertW AlbertW is offline
harker robotics :. 1072
AKA: Aonic
#1072 (Harker Robotics)
Team Role: College Student
  
Join Date: Oct 2002
Rookie Year: 2003
Location: San Jose, CA
Posts: 323
AlbertW is on a distinguished road
Send a message via AIM to AlbertW
Re: Lasercutting Spur Gears?
quick note aobut water-jet cutting... the last time i had something water-cut, the jet spray expanded the further it went, so we ended up with a non-perpendicular edge (if only barely, but it was noticable, and it was only 1/4 inch thick.)

so i don't think water-jet cutting would be the best for sprockets, considering they have to mesh. laser might work, but water definitely won't.
__________________

We were the first seeded first-year team at a first-year FIRST regional.