|
Re: gear ratios
You may want rethink using the drill motor geaxboxes, they are more trouble than they're worth. While we didn't use a gearbox, we mated the chip and drill motors to a comon shaft with sprockets and chains. The chip ran a 9 to 9 tooth, while the drill ran a 9 to 32 tooth. The match was so good, the software that was written to equalize the two motors wasn't needed. On the dyno we put out .55 hp.
__________________
If you think you can, or if you think you can't, you're probably right.
2005 Palmetto AutoDesk Award
2005 Palmetto Judges Award
2005 Palmetto Semi-Finalists
2005 NJ Regional Chairmans Award
2005 NJ Regional Finalists
2004 Curie Div. 5th Seed
2004 Palmetto Regional Winners
2004 Palmetto DC Team Spirit Award
2004 Chesapeke Semi-Finalists
2004 Trenton Semi-Finalists
|