Thread: Maximum Depth of Cuts
View Single Post
  #5   Spotlight this post!  
Unread 07-05-2004, 13:51
indieFan indieFan is offline
RoboDox and LVHS - Missing you!
FRC #5941
Team Role: Engineer
  
Join Date: Jan 2002
Rookie Year: 2001
Location: Seattle (was SoCal, then SA,TX))
Posts: 382
indieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond reputeindieFan has a reputation beyond repute
Re: Maximum Depth of Cuts
Wait, I may have terminology screwed up. I thought DOC referred to either the depth that the end of a tool sank into a material OR the amount that a tool removed on its side. If not, is the latter referring the the Material Removal Rate (MRR)?

Regardless, I'm looking at how to figure out how much material can be removed using the side of the tool.

indieFan