Thread: Drill motor gear measurement
View Single Post
  #9   Spotlight this post!  
Unread 23-06-2004, 12:03
Gary Dillard's Avatar Unsung FIRST Hero
Gary Dillard Gary Dillard is offline
Generator of Entropy
AKA: you know, the old bald guy
FRC #2973 (The Mad Rockers)
Team Role: Engineer
  
Join Date: Nov 2001
Rookie Year: 1998
Location: Huntsville, AL
Posts: 1,584
Gary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond reputeGary Dillard has a reputation beyond repute
Send a message via AIM to Gary Dillard
Re: Drill motor gear measurement
This was discussed before - pay attention to the advice on running in the brass gears under no load:

http://www.chiefdelphi.com/forums/sh...t=pinion+brass
__________________
Close enough to taste it, too far to reach it