Thread: frying control board
View Single Post
  #1   Spotlight this post!  
Unread 07-07-2004, 05:29
Denman's Avatar
Denman Denman is offline
Tie Wrap-Not Cable Tie or Zip tie
AKA: Stephen Denman
FRC #0759 (Systemetric)
Team Role: Mentor
  
Join Date: Jan 2004
Rookie Year: 2003
Location: Cambridge UK
Posts: 817
Denman has much to be proud ofDenman has much to be proud ofDenman has much to be proud ofDenman has much to be proud ofDenman has much to be proud ofDenman has much to be proud ofDenman has much to be proud ofDenman has much to be proud ofDenman has much to be proud of
Send a message via ICQ to Denman Send a message via AIM to Denman Send a message via MSN to Denman Send a message via Yahoo to Denman
frying control board
Just a quick question.
Our robot is made out of inch square angle , and i need to do a bit of welding on the lifter (its from the box lifter one)
what i want to know is, if i do some MiG welding on the robot lifting arm (the vertical bits) will it blow up the control board? It is bleeding hard to get the control board out as i will have to remove EVERYTHING else....
__________________
I am an ex-member of team 759.
759: regional winners with 522 and 233 NYC (2004)


FIRSTWiki.org - Contribute, learn, inspire.

"Teach the way of the GP and the way of the GP shall teach you" - Me