|
Re: Motor Info
When using two different motors, you should always make sure that they are geared so their free speeds match. This means you should be using the same percentage of each motor In this case, the ratio between the ratios for drill to CIM should be 19500/5500 or about 3.7. (112/28 != 19500/5500). This is probably a bit hard to understand, but there are numerous posts about this all over the forum with much longer, and well written explanations of why free speeds need to match and such...
__________________
Learn, edit, inspire: The FIRSTwiki.
Team 1257
2005 NYC Regional - 2nd seed, Xerox Creativity Award, Autodesk Visualization Award
2005 Chesapeake Regional - Engineering Inspiration Award
2004 Chesapeake Regional - Rookie Inspiration award
2004 NJ Regional - Team Spirit Award
|