With this years game being a contact sport, we prepared for this. We obtained a piece of 35mm DIN rail (legal - extruded aluminum) which the breaker snaps onto. We took two of the shock mounts which were supposed to be used for the compressor to mount the DIN rail to the robot frame. The #6 wires are not tied down near the breaker. This is very forgiving.
We have been hit hard and only have dents but no breaker trips.
Hope this helps, (looking for pics)
Mike
See our robot at:
http://www.chiefdelphi.com/forums/sh...&threadid=3479