|
Re: Andymark.biz
Andy:
For the omni wheels, the assembly drawing and the step file show the inner 6 button head screws at 60 degrees installed from one side; the photo shows 3 at 120 degrees. I'm guessing the other 3 are on the other side, since it allows both plates to be the same part by clocking it (the step file shows the clearance) - is that correct? Could made a difference if someone were putting that face close to a mount bearing and didn't leave clearance for the screws.
Looks pretty sweet, for sure. We're still working on Mod 3 to our omni wheels - depending on resources we may use yours come build season though.
__________________
Close enough to taste it, too far to reach it
|