Thread: CIM speed in reverse?
View Single Post
  #7   Spotlight this post!  
Unread 20-11-2004, 12:00
aaronbr28040's Avatar
aaronbr28040 aaronbr28040 is offline
Registered User
AKA: Aaron Bradshaw
#0900 (Team Infinity)
Team Role: College Student
  
Join Date: Jan 2004
Rookie Year: 2004
Location: Raleigh, NC
Posts: 135
aaronbr28040 is just really niceaaronbr28040 is just really niceaaronbr28040 is just really niceaaronbr28040 is just really nice
Send a message via AIM to aaronbr28040
Re: CIM speed in reverse?
Another thing to check, make sure that the drill motors are both shifted into the correct gear tightly. I know this may sound dumb, but I actually had a problem with this and it took me a long time and a few posts on here to figure it out. I'm probably the only one dumb enough to do that but I just wanted to throw the idea out there. Good luck with getting it straightened out.
-Aaron
__________________
@North Carolina State University
Team 900
North Carolina School of Science and Mathematics
AIM:aaronbr28040