Quote:
|
Originally Posted by SirLancelot
How does one extrude 2D figures on AutoCAD? I'm very new at this.
|
First, you must have a region to extrude. The region command can be used to create the region(s) that you wish to extrude. To region lines/plines/splines, there must be an unbroken perimeter to use as the base for the region.
Once the object is regioned, then you extrude using the command of the same name, and follow the instructions in the command line:
select the object(s) to be extruded, hit enter
type in the height of extrusion, in the base units of the drawing, hit enter, or goto <path>
put in the taper angle that you wish to be used in the extrusion, hit enter
<path> to select the path option, you must first have a line or pline to extrude along, and then do the extrude command. Select the object to extrude, enter, p(ath), enter, click on the path, enter
Hope this helps!
Squirrel
---------------------
If it doesn't, then pm me or email me at
squirrel.rock@gmail.com.
However, I check my pms more often than my email, because I cannot access my gmail at school, but I'm typing this while at school
.