Quote:
|
Originally Posted by Noah Melamed
our Victors had plastic notches where the Mold had been punched out for the PWM cable. We have assumed they are a defect and pinched them off with needle nose pliers. Before we did this we could not insert the PWM cable after words the cables insert fine and work flawlessly
|
Yea we have the same notches well we took them off now too, as we found out they are only little defects from the molds, thankyou for confirming this.
As for other repliers, i am sorry if my explanation was too vague. I suppose its only some of the units that have these notches and no they are not the protrusions, i am not that stupid
. Anyways its hard to explain unless you guys also have a victor with the same problem(or defect).