Thread: Pinion not machined correctly
View Single Post
  #2   Spotlight this post!  
Unread 14-01-2005, 10:13
InnovationFirst's Avatar
InnovationFirst InnovationFirst is offline
Official FIRST Supplier
no team
  
Join Date: Nov 2002
Location: Greenville, Tx
Posts: 28
InnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond reputeInnovationFirst has a reputation beyond repute
Re: Pinion not machined correctly
Quote:
Originally Posted by Coachmac
So, were putting the drivetrain and gear boxes together last night and we hit a snag. on the second gear box, the pinion (FRC-2005-112-005) on the small shaft is milled wrong. The center is twisted and will not go on to the shaft completely. Has anybody else run into this? How did you remedy the situation? Did you just buy a new one? Should there be a replacement at no cost to us? thanx
Please refer to the thread at the IFIrobotics forum: http://www.ifirobotics.com/forum/viewtopic.php?t=174