Thread: Drive Assembly Sprockets are Custom Bored
View Single Post
  #8   Spotlight this post!  
Unread 14-01-2005, 11:33
Joel Glidden's Avatar
Joel Glidden Joel Glidden is offline
My heart pumps diesel.
FRC #4293 (Komodo)
Team Role: Engineer
  
Join Date: Apr 2002
Rookie Year: 2001
Location: Highlands Ranch, CO
Posts: 208
Joel Glidden is a glorious beacon of lightJoel Glidden is a glorious beacon of lightJoel Glidden is a glorious beacon of lightJoel Glidden is a glorious beacon of lightJoel Glidden is a glorious beacon of lightJoel Glidden is a glorious beacon of light
Re: Drive Assembly Sprockets are Custom Bored
You could also turn down the output shafts to 5/8" on your handy dandy lathe. You could also mill a 3/16" keyway on the opposite side of the shaft from the existing 5mm keyway.

-Joel