Thread: THE Fisher-Price Motor Spec Sheet
View Single Post
  #26   Spotlight this post!  
Unread 17-01-2005, 19:20
Mr.G Mr.G is offline
Registered User
AKA: Kevin
FRC #0326 (Xtreme Eagles / Romulus High School / General Motors)
Team Role: Engineer
  
Join Date: Dec 2002
Rookie Year: 2001
Location: Romulus
Posts: 244
Mr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond reputeMr.G has a reputation beyond repute
Send a message via AIM to Mr.G
Re: THE Fisher-Price Motor Spec Sheet
Joe,
I don't know if you can get a good view of the armature, but an inferred thermometer may work. With the motor spinning I think you would get the average of the whole armature, and not just the windings. But if you stop it you could get a peak temp reading. Some IR thermometers have a wide measuring spot like a 1/2 inch or more closeup.