|
Re: WARNING- New camera meets magic smoke
The following is quoted from the camera manual:
Quote:
|
The servos can either be powered by internal power or by the external servo power connector. To run them from internal power, connect a jumper across the “internal power to servo” jumper. To run them off of external power, leave the “internal power to servo” jumper open, and connect an external 5-volt power supply to the “external power to servo” connector.
|
The included diagram is from the camera manual.
NOTE: The first setup assumes that the camera is connected such that the servos are powered from a PWM cable connected to the Robot Controller.
The camera pin diagram can be found on page 12 of the manual.
__________________
Team 1097 -- Site 3 Engineering ~~~~~~~~~~~~~~~~~~~~ 2003 Sacramento Rookie All Star 2003 Silicon Valley Rookie All Star 2004 Sacramento Engineering Inspiration Award 2004 Sacramento Visualization Award 2004 Outstanding Volunteer Award (G. Glasser) 2004 Silicon Valley Sportsmanship Award
2004 National Visualization Runner Up
2004 Cal Games Finalist
2005 Sacramento Sportsmanship Award
2005 Sacramento #1 seed
2005 Sacramento Finalist
2005 Silicon Valley Sportsmanship Award
2005 Silicon Valley #1 Seed
2005 Silicon Valley Finalist
|